Weigl Works ProCommander LX Controller Windows Vista 64-BIT

Taking Control - Help for Women and Children . 3rd Working Conference on Reverse Engineering, Nel Corso Di Anni LX. del Secolo XVII., Volume 3, Giovanni Targioni-Tozzetti Green Street Hooligans, Marcel Weigel. ENT Show Control Professor John Huntington Application Software: Venue Magic Play Back Controller. ProCommander 3: Comprehensive Show Control Solution. Engineered using the highest level of quality standards, this controller supports a wide variety of  Missing: LX.

RS 1 If these serial parameters are changed, the transmitter must be changed to the same parameters!

Weigl Control - Animatronics and Motion Control Be in Control

Maximum length of a serial string for port RS 1: Commands marked in this colour are not implemented yet! Commands marked in this colour are only possible in the Control.

Each command starts with a "! The programmer has to take care about the correct syntax!

Weigl Works Procommander Lx Controller Firmware Driver Download

Wrong commands are ignored or lead to a unexpected result! Set port1 port4 Port [ ]! Set sub net mask Sub Net Mask! Merge Combine If Merge Mode is enabled, it is only valied between start and end channel.!

Merge Mode disabeld default. Output is the lowest value of both DMX signals.

• Download Weigl Works Firmware drivers
• ProCommander® LX 2 – Weigl Control Worldwide
• ProCommander® LX 2
• WEIGL ASCII Commands for ProCommander Series, WEMC 1 & ProIO Series
• ProCommander LX Introduction

Output is the highest value of both DMX signals. Output is that value, which has changed at last. Even, Odd, No parity; Stopbits: Set DMX2Analog start channel.

DMX Start channel [1 ] for Analog map! A 1 indicates, that the corresponding DMX channel is mapped to the analo output. With a 0 the DMX channel will be ignored and the analog output may be controlled internally.!

Set DMX2Digital start channel. DMX Start channel [1 ] for Digital map! A 1 indicates, that the corresponding DMX!

All 16 digital outputs are mapped to the DMX channels. The digital outputs 1 4 and 9 12 are mapped to the DMX channels. Set DMX read in 1: Disable DMX read in.!

Set DMX time out Time: Set time code time out Time: Set time code create 0: Set ease in time Time: Set analog min value Output channel: Set analog max value Output channel: If the new min value is greater than the current max value, the min value will be limited to the max value! Set analog max value of analog output 1 to If the new max value is less than the current min value, the max value will be limited to the min value!!

Weigl Works ProCommander LX Controller WemNet Port number Port 2 is the default port.

Set Port number 3 default as port, where cues are sent to ProIO devices.! Y Set daisy chain baud rate X: Baud rate; possible values: This is the default mode and must be used, if the first ProIO A1 is connected via network.!

All units must be rebooted after that command. Change port1 port4 Port [ ]! Change sub net mask Sub Net Mask!

Change master volume Master Volume [0 31] value